A concentrated, fully soluble biostimulant that pairs 100% soluble humic acid with cold-processed kelp extracts in a 5:2 ratio. Built to feed soil biology, improve nutrient uptake, and deliver marine polysaccharides and natural growth compounds in a single, tank-friendly powder. Suitable for foliar spraying, fertigation, soil drenching, and seedling treatment across vegetables, orchards, vineyards, turf, ornamentals, and broadacre crops.
What It Does
The humic fraction acts as a carbon source and chelator, holding nutrients in plant-available forms and stimulating soil microbial activity. The kelp fraction contributes alginic acid, natural growth-promoting compounds, and a broad spectrum of trace elements. Together they support stronger root development, improved stress tolerance through frost and drought, better nutrient use efficiency, and more resilient soil biology. Because it is 100% soluble, it dissolves cleanly for both small hand mixes and large commercial batches.
Application Rates
Home Garden & Small Mixes
Foliar spray: 1g per litre. Move toward 2g per litre only where you need heavier coverage, and test-spray sensitive or light-coloured foliage first to check for staining.
Soil drench: 1g per litre as a general working strength. For a heavier soil-building pass, increase up to 2 to 3g per litre.
Watering can: add 1 teaspoon to a 9L watering can and water in around the base of the plant.
Spot spraying: 10g per 10L of water for targeted, small-area treatments.
Commercial & Field Crops
Vegetables: foliar at 100g per 100L of water, up to 750g per hectare. Fertigation at 1kg per hectare. Apply every 1 to 2 weeks or as required.
Orchards & vineyards: foliar at 100g per 100L of water, up to 1kg per hectare. Fertigation at 1kg per hectare. Apply prior to flowering or as required.
Ornamentals, natives & turf: foliar at 100g per 100L of water, up to 750g per hectare. Fertigation at 1kg per hectare. Apply as required.
Broadacre crops: 100 to 200g per hectare in 60 to 100L of water, depending on canopy closure. Apply as required.
Pasture: 100 to 200g per hectare in 60 to 100L of water. Apply as required.
Seedlings, Cuttings & Transplants
Rooting: dip cuttings in a 1:1000 solution (1g per litre) before planting.
Seedlings: dip seedlings in a 1:1000 solution (1g per litre), or fertigate immediately after planting at 1kg per hectare.
Transplants: apply as a soil drench at 1g per litre at the base of new transplants to reduce shock and support early root establishment.
Mixing Instructions
Always dissolve the powder on its own before adding anything else to the tank. Fill your mixing vessel with water first, then slowly sprinkle the powder in while stirring continuously. A paint stirrer on a drill works very well for this. To avoid clumping, dissolve no more than 500g of powder per 20L of water. Mix for a few minutes until fully dissolved, then filter the liquid before pouring it into the spray or fertigation tank.
For larger or commercial batches, a closed-circuit system such as a Venturi pump gives the cleanest, most complete dissolution. Once the powder is fully dissolved and filtered, top up to your final spray or drench volume and apply.
Timing & Stress Periods
Additional applications can be made immediately before or after stress periods such as frost, drought, or transplanting. It is always preferable to increase the frequency of applications rather than the concentration of the solution.
Where higher water rates are required for good foliar coverage, do not exceed the maximum product rate per hectare. Add water, not additional product. Frequencies are a guideline only and can be adjusted to suit your farm practices and crop monitoring. Ensure suitable spray conditions, including appropriate temperature, humidity, and wind speed, before any foliar application.
Soil Testing & Rates
Soil tests should be completed first so you can apply the correct rate for your agronomic conditions. Rate variations are a normal result of differing soil conditions, and the rates above are a guideline rather than a prescription.
Guaranteed Minimum Analysis
Soluble Potash (K₂O) ....... 15.0%
Humic Acid* ............... 42%
Alginic Acid .............. 5%
*Humic acid content determined by the ISO 19822 (HPTA-approved) test method.
Derived from soluble humic acid powder and soluble kelp extracts (Laminaria, Sargassum, and Ascophyllum nodosum
Storage & Safety
Store in a cool, dry place away from direct sunlight. Keep the bag sealed between uses so the powder stays dry and free-flowing. Keep out of reach of children and pets.
This product complies with Canada's Organic Production Systems General Principles and Permitted Substances Lists (CAN/CGSB-32.310-2026, CAN/CGSB-32.311-2026).
